Skip to content

Support settlements

Prescribed displacements and rotations at supported nodes and line supports, scaled by the combination factor, and why an unsupported direction is ignored.

Loads & combinations 3 min read

A settlement moves a support by a set amount. In Elementarium it is a load of its load case: it acts in that case only, and a combination scales it by the case's factor, as it would a force. It can be a translation or a rotation, at a node or along a line support.

Placing one

Loads › Special loads › Settlement places one at a node. The arrow beside it holds Line settlement, and both are also under the arrow on Point load in Home › Loads. The settlement lands in the active load case, like any other load.

  • At a node. Each direction is free until you switch it to set and give a value. A settlement prescribes only the directions it names.
  • Along a line support. Pick the line support. Each direction takes one value at the line's start and one at its end, and varies linearly by length between them. The buttons in the table's header swap the ends or make them equal.

Values are in the project's displacement and angle units, in the global axes, which are the axes of the support. The directions offered follow the model type: a plane frame has no , and a truss has no rotations.

A direction needs a rigid support

A settlement moves a support, so it acts only on a direction that support holds rigidly. Anywhere else it would invent a support that is not in the model: 5 cm prescribed along a free would pin the node there. A spring is not rigid, so a direction on a spring does not count either.

A direction without a rigid support is ignored:

  • The load editor will not let you set it, and says why.
  • If the support changes afterwards, the model check reports Prescribed displacement without a support or Line settlement without a support, and the viewer marks the direction as ignored.
  • The settlement's properties name the direction, with Make … rigid to fix it.

For a line settlement, the directions are the ones that line support holds rigidly.

In a combination

A settlement is scaled with its case. A settlement of 10 mm in a case that a combination takes at 1.35 moves the support 13.5 mm in that combination, and its internal forces scale by the same factor. A case that a combination leaves out leaves its settlement out too.

Give a settlement a load case of its own, so it can be factored and grouped apart from everything else. See Load cases.

Second-order analysis and a buckling reference state solve a load state as a whole, and a settlement in it is scaled the same way. A settlement stresses a structure only where it is statically indeterminate: a simply supported beam follows its support and carries nothing.

Where two settlements meet

There is one value per case, node and direction. A nodal settlement on a node of a line, or two lines meeting at a corner, do not add up: the first one stated stands, nodal before line. Settlements in different load cases do add up in a combination, like any two cases.

In reports and files

  • The report lists settlements with the other loads of a case.
  • IFC writes a nodal settlement as a displacement load on the node. A line settlement is not written, and the export warns that it was skipped.
  • SAF writes a nodal settlement as a deformation of the support. It writes no line supports yet, so a line settlement is not exported and the dialog says so.

See Import & export formats.

Load cases covers how a case is built and grouped. Supports and releases covers what a rigid direction is. Temperature loads is the other action that stresses a structure only by restraint.

Something wrong or unclear on this page? Tell us, and it gets corrected.